How To Recover A Glider Rocker Without Sewing

How to Reupholster a Glider Rocker Cushion

Finding a glider rocker is relatively easy: they're sold in most article of furniture stores, mass retail stores and even thousand sales and second-mitt shops. Finding ane to match your home's decor, all the same, is another task entirely.

Plough your glider rocker from drab to fab by reupholstering the cushions.

Don't settle for factory default upholstery for your glider rocker; learn to reupholster a glider rocker cushion on your own and yous can match your glider rocker to whatsoever pattern theme or decor programme. You will need bones sewing skills for this project to be successful.

Tip

If your absorber had ties originally, use ribbon to supplant them. Cut the ribbon to the length of the original ties, then fold information technology in half and sandwich the fold betwixt the seams of the fabric at the 2 back corners as you sew. When yous turn it right side out, the ribbon will hang out of the pillow, ready to tie information technology to the rocker.

Apply a seam ripper or a pocket-size pair of sharp sewing scissors to gently rip out the buttons from the cushion of your glider rocker, if it has any. Also rip open the seams going around the sides or bottom of the cushion, being careful to preserve the actual cloth and only rip through the thread.
Pull the embrace entirely off the cushion, using the seam ripper or pair of scissors to carve up it into its original pieces. Lay these out flat on elevation of your fabric, with the wrong side of the fabric facing up and the right side of the cushion covers facing down.
Trace around the cushion cover fabric pieces onto your new upholstery cloth. Use a fabric mark pen or chalk to make your tracing lines. Cutting out the pattern pieces from your new material.
Place your two new cushion fabrics together with the right sides facing one another. Sew around the sides of the pieces to sew them together. Position your seam as close to the original seam width from the cushion encompass you removed as y'all tin can; in general this should be 1/4 to i/ii inch. Exit ane section of the edging unsewn, approximately 10 inches long.
Trim off the excess material outside of your seams. At the corners of your pillow cover, cutting slits in the fabric in a perpendicular direction to the seam itself, going around the corner equally you do and then. These piddling slits volition aid the corners look more uniform in the finished cushion.
Turn the new cushion cover right side out through the hole you lot left in one side. Make full the cushion cover with the filling from the old cushion. Fold the seams from the open edge in toward the inside of the cushion and pin them together, and then stitch this seam closed using your automobile or a needle and thread.
If the original cushion had buttons, arrange your new buttons in approximately the same location on the new cushion. Employ a needle and thread to mitt sew the buttons onto the absorber, going through all of the layers of the fabric and padding. You may need to use a sturdy embroidery needle and thread for this to ensure that the push stays in place and that you lot tin go the needle through all of those layers.

The Drip Cap

Finding a glider rocker is relatively like shooting fish in a barrel: they're sold in most furniture stores, mass retail stores and even yard sales and second-hand shops.
Trace effectually the cushion cover textile pieces onto your new upholstery fabric.
Cut out the pattern pieces from your new fabric.
At the corners of your pillow cover, cut slits in the cloth in a perpendicular management to the seam itself, going around the corner as you lot do so.
Use a needle and thread to hand run up the buttons onto the cushion, going through all of the layers of the fabric and padding.

Source: https://homesteady.com/13403566/how-to-reupholster-a-glider-rocker-cushion